SilverCrest SFPM 600 A1 Mode D'emploi page 44

Required accessories:
- Axle 9
- Working container 8
- Adapter 7
- Whisking disc 17
- Lid 3 with food pusher 1
Work steps:
1. Figure B: place the axle 9 on the base
unit 12.
2. Figure C: position the working con-
tainer 8 in position a on the base
unit 12. Turn the working container
clockwise slightly until it audibly clicks
into position b.
3. Figure D: place the adapter 7 on the
axle 9.
4. Place the whisking disc 17 on the
adapter 7. Turn the whisking disc 17
back and forth slightly until it sits on the
bottom.
5. Fill the ingredients into the working con-
tainer 8. Further ingredients can be
added at a later time through the food
chute 2.
6. Figure E: place the lid 3 on the work-
ing container 8. Turn the lid slightly in a
clockwise direction until it audibly clicks
into place.
42 GB
7. Figure G: place the food pusher 1
into the food chute 2.
8. Connect the mains plug 10 to a wall
socket.
9. Use the dial 11 to select the desired
speed setting.
10. When the process is completed, switch
the dial 11 to 0 and pull out the mains
plug 10.
11. Turn the lid 3 with the food pusher 1
slightly in an anticlockwise direction
and remove it.
12. Turn the working container 8 slightly
anticlockwise and remove it.
13. Pull the axle 9 downwards from the
working container 8.
14. Remove the adapter 7 together with the
whisking disc 17 upwards and remove
the prepared food from the working
container 8.
15. Clean all of the accessories that have
been used immediately if possible.