Arktic 233610 233627 233634 233641 233658 233665 233696 Mode D'emploi page 9

Troubleshooting
If the appliance does not function properly, please
check the below table for the solution. If you are
Problems
The appliance does not
start cooling after con-
nect to electrical power
supply.
Cooling is not enough.
Too much noise
Possible cause
Thermal cut-out activated
The compressor is defective.
The power plug is connected correctly with
the power supply outlet.
The appliance is under strong sunlight ra-
diation or close to a heat source.
The doors are not properly closed or the
sealing gasket is defective.
Too much food is placed inside the appli-
ance.
Surrounding ventilation is insufficient.
The appliance is not placed horizontally.
The appliance touches surrounding wall
or other objects.
The appliance touches surrounding wall
or other objects.
still unable to solve the problem, please contact the
supplier/service provider.
Contact with the supplier/service provider
for repair.
Check the connection and make sure all
the connections are correctly connected.
Move the appliance a new location to avoid
direct sunlight.
Close the doors properly.
Place less food inside the appliance.
Check that if sufficient ventilation is pro-
vided by allowing at least 10cm away from
other objects or wall.
Check to make sure the appliance is
placed horizontally.
Check to make sure that at least 10cm
away from other objects or wall.
Contact with the supplier/service provider
for repair.
Possible solution
EN
9