Electrolux EOA6841 Notice D'utilisation page 31

Removing the side rails
1
Installing the shelf supports
Install the shelf supports in the opposite
sequence.
The rounded ends of the shelf
supports must point to the front.
11.3 Catalytic walls
The walls with catalytic enamel are self-
cleaning. They absorb fat which collects
on walls when the oven operates.
To support the self-cleaning process:
1. Activate the oven lamp.
2. Remove the accessories from the ap-
pliance.
3. Clean the oven floor with warm water
and washing-up liquid, then dry it.
4. Set the function
temperature.
5. Let the empty appliance operate for
one hour.
6. When the appliance is cool, clean it
with a soft and moist sponge.
2
and maximum
1.
Pull the front of the shelf support rail
away from the side wall.
Hold the rear shelf runners and cata-
lytic panel in place with the other
hand.
2.
Pull the rear shelf support rail away
from the side wall and remove it.
WARNING!
Do not clean the catalytic surface
with oven sprays, abrasive clean-
ing agents, soap or other cleaning
agents. There is a risk of damage
to the catalytic surface.
WARNING!
Keep children away when you
clean the oven at a high tempera-
ture. The oven surface becomes
very hot and there is a risk of
burns.
Discolouration of the catalytic sur-
face has no effect on the catalytic
properties.
11.4 Oven lamp
WARNING!
Be careful when you change the
oven lamp. There is a risk of elec-
trical shock.
Before you change the oven lamp:
• Deactivate the oven.
• Remove the fuses in the fuse box or
deactivate the circuit breaker.
ENGLISH 31