Electrolux EOA6841 Notice D'utilisation page 11

Masquer les pouces Voir aussi pour EOA6841:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

5.5 Steam cooking
The water drawer cover is in the
control panel.
1.
Press the cover to open the water
drawer.
2.
Fill the water drawer with 900 ml of
water.
The water supply is sufficient for ap-
proximately 55 - 60 minutes.
Do not put water directly into the
steam generator.
Use only water. Do not use filtered
(demineralised) or distilled water.
Do not use other liquids. Do not
put flammable or alcoholic liquids
into the water drawer.
3.
Push the water drawer to its initial po-
sition.
4.
Activate the appliance.
5.
Prepare the food in the correct cook-
ware.
6.
Select the steam heating function and
temperature.
7.
If necessary, set the function Duration
or End Time
The signal sounds at the end of the
cooking time.
8.
Deactivate the appliance.
Let the appliance dry fully with the
door open.
9.
Empty the water tank after the steam
cooking is completed.
WARNING!
Wait a minimum of 60 minutes af-
ter each use of the steam cooking
in order to prevent hot water from
exiting the water outlet valve.
5.6 Tank Empty indicator
The display shows Water required and an
acoustic signal sounds when the tank is
empty and must be refilled.
For more information refer to "Steam
Cooking".
5.7 Tank Full indicator
When the display shows Water tank full ,
you can use the steam cooking.
An acoustic signal sounds when the tank
is full.
5.8 Emptying the water tank
1.
.
2.
3.
4.
5.
If you put too much water into
the tank, the safety outlet
moves the excess water to the
bottom of the oven.
Remove the water with a sponge
or cloth.
Make sure that the appliance is
cool before you start to empty the
water tank.
Prepare the draining pipe (C), inclu-
ded in the same package with the
user manual. Put the connector (B)
onto one of the ends of the draining
pipe.
A
B
C
Put the second end of the draining
pipe (C) into a container. Put it at a
lower position than the outlet valve
(A).
Open the oven door and put the con-
nector (B) into the outlet valve (A).
Push the connector again and again
when you empty the water tank.
Remove the connector from the valve
when the water stops flowing.
WARNING!
Do not use the drained water to fill
the water tank again.
The tank can have some water
when the Tank Empty indicator
is on. Wait until the water flow
from the water outlet valve stops.
ENGLISH
11

Publicité

Chapitres

Table des Matières
loading

Table des Matières