Appendix; Overview Of Individual Symbols - Wilo Control SC-L Notice De Montage Et De Mise En Service

English
• On-site support from Wilo customer service
• Inspection or repair of the switchgear at the
factory
Please note that you may be charged for some
services provided by our customer service.
For more details, please contact Wilo customer
service.

11. Appendix

11.1. Overview of individual symbols

Back (brief press: one menu level; long press: main
screen)
EASY menu
EXPERT menu
1st meaning: Service not registered
2nd meaning: Display value – no entry possible
Service
Parameters
Information
Fault
Reset error
Alarm settings
Error in power supply (phase error, incorrect rotat-
ing fi eld, low voltage)
Error in motor winding (WSK, PTC, impermeability)
External off
Pump
Pump 1
Pump 2
Pump 3
Pump 4
Pump cycling
Time-dependent pump cycling
50
Pump test run
Maximum pump running time
Setpoints
Activation and deactivation thresholds
Actual value
Sensor: Signal type
Sensor: Measurement range
Pump activation and deactivation delay times
Delay time
Follow-up time
Operating mode
Operating mode of the switchgear
Pump operating mode
Standby
Limit values
Switchgear data
Controller type; ID number; software/fi rmware
Operating hours
Operating hours of pump 1
Operating hours of pump 2
Operating hours of pump 3
Operating hours of pump 4
Switching cycles
Switching cycles of pump 1
Switching cycles of pump 2
WILO SE 05/2016 V05 DIN A4
APPENDIX