Starting And Stopping; Before Starting; Starting; Stopping - Husqvarna PG 530 (ph 1) Manuel D'utilisation

Before starting

WARNING! Please read the operator's
!
manual carefully and make sure you
understand the instructions before using
the machine.
Wear personal protective equipment. See
instructions under the heading "Personal
protective equipment".
Make sure no unauthorised persons are
in the working area, otherwise there is a
risk of serious personal injury.
• Check that the machine is assembled correctly and do
not show any signs of damage. See instructions in the
section "Assembling and adjustments".
• Perform daily maintenance. See instructions in the
section "Maintenance".
Use the STOP/RUN switch to control the running of the
machine, not the EMERGENCY STOP button. Each
time the EMERGENCY STOP button is pressed it shuts
down the drive/frequency converter. Frequently
powering up and down of the drive/frequency converter
will reduce the life span of the drive/ frequency
converter.

Starting

• Check that the emergency stop button is not pressed
by turning it clockwise.
POWER
FWD/REW
RESET
DISC SPEED STOP/RUN
• Check that the STOP/RUN switch is set to STOP.
POWER
FWD/REW
RESET
DISC SPEED STOP/RUN

STARTING AND STOPPING

• Press the power button. On doing so, a soft 'clunk"
should be heard to come from within the electrical
cabinet. This indicates the line contactors have
engaged, supplying power to the drives/frequency
converters.
POWER
FWD/REW
RESET
DISC SPEED STOP/RUN
• Reduce the pressure between grinding disc and floor
by pushing down the handle without lifting the grinding
unit from the floor when starting.
• Switch the machine to run mode using the STOP/RUN
switch on the control panel. The machine should start
smoothly and accelerate to the selected speed over a
period of 5 seconds
POWER
FWD/REW
RESET
DISC SPEED STOP/RUN

Stopping

Turn the stop/run switch to "STOP".
POWER
FWD/REW
RESET
DISC SPEED STOP/RUN
–
English 21