Setting Date And Time - LEGRAND VR61-18 Manuel De L'utilisateur

➢ System restart after a shutdown due to EPO activation
Several specific blocking conditions of the power modules can only be cleared by directly
entering the Settings section of the modules (see relevant paragraph).
For a description of the UPS status in each of the failure conditions listed above, please refer
to the "Faults and alarms" section.

5.3.2 Setting date and time

Date and time may be set via the CLOCK page.
Picture 19 – Clock manual setting
Setting the current date and time correctly
The correct setting of the date and time is essential for the recording of the event log.
The system also allows the setting of a NTP server for the synchronization of date and time.
Such configuration mode is enabled by pressing the label Disabled. As the NTP server is
enabled the data can't be manually entered anymore.
UPS user manual
Manuel de l'utilisateur de l'ASI
Utilizzo dell'UPS
OMP06145 REV. D 33