The Set Setting Menu - Sony VPL-PX40 Mode D'emploi

The SET SETTING
Menu
The SET SETTING menu is used for
changing the settings of the projector.
NPUT
YSTONE
SET SETTING
S m a r t A PA : O n
HELP
Au t o I n p u t S e a rch : O f f
I n p u t - D S i g n a l S e l : C o m p u t e r
ASER
C o l o r S y s t e m : Au t o
S p e a k e r : O n
Pow e r S av i n g : O f f
I R R e c e i v e r : F ro n t & R e a r
I l l u m i n a t i o n : O n
Menu Items
Smart APA
Activates or deactivates the Smart APA
On: Normally select this setting. When a
signal is input from a computer, the APA
functions automatically so that the
picture can be seen clearly. Once the
specified input signal has been adjusted
by the Smart APA, it will not be
readjusted even when the cable is
disconnected and connected again or the
input channel is changed. You can adjust
the picture by pressing APA key on the
Remote Commander even if the Smart
APA set to "On."
Off: The APA functions when you press the
APA key on the Remote Commander.
1) The APA (Auto Pixel Alignment)
automatically adjusts "Dot Phase," "H Size"
and "Shift" in the INPUT SETTING menu
for the input signal from a computer.
VOLUME
Input A
INPUT
LAMP/ TEMP/ POWER
COVER FAN SAVING ST
1)
.
Auto Input Search
Normally set to "Off."
When set to "On," the projector detects input
signals in the following order: Input-A/
Input-B/Input-C/Input-D/Video/S-Video. It
indicates the input channel when the power
is turned on or the INPUT key is pressed.
Input-D Signal Sel.
Selects either a computer signal, a
component signal or a video GBR signal
(15k RGB, DTV, HDTV) for the signal that
is input to the INPUT D connector.
Color System
Selects the color system of the input signal.
If you select "Auto," the projector detects
the color system of the input signal
automatically. If the picture is distorted or
colorless, select the color system according
to the input signal.
Speaker
Set to "Off" to cut off the sound of the
internal speakers. When set to "Off,"
"Speaker: Off" appears on the screen when
you turn on the power.
Power Saving
When set to "On," the projector goes into
power saving mode if you do not operate the
unit for 10 minutes with no signal input.
IR Receiver
Selects the remote control detectors (IR
receiver) on the front and rear of the
projector.
Front&Rear: Activates both the front and
rear detectors.
Front: Activates the front detector only.
Rear: Activates the rear detector only.
Illumination
Selects whether the SONY logo on the top of
the projector lights when the projector is on.
Normally, this setting is "On". If you want
complete darkness or if the illuminated logo
is a distraction, change this setting to "Off".

The SET SETTING Menu

35
GB