Using Disposable Sleeves; Cleaning The Inside Of The Sleeve Window - Dentsply Sirona CEREC Primescan AC Notice D'utilisation

6 Maintenance
6.1 Cleaning, disinfection and sterilization
72
6.1.4.9

Using disposable sleeves

The CEREC Primescan / Primescan / CEREC Omnicam / Omnicam
scanner can be operated with disposable plastic sleeves in order to
ensure maximum infection control. The sleeves are available using
order number 66 86 880.
NOTE
The disposable sleeves cannot be used in the following
circumstances:
- when using color analysis.
1. Following each patient, remove the disposable sleeve from the
scanner body and dispose of it according to the standard
procedure.
2. Clean the scanner head with a dry cloth.
3. Remove one disposable sleeve from its packaging. Slide the sleeve
up to the stop on the scanner body, so that it is securely positioned
on the CEREC Primescan / Primescan / CEREC Omnicam /
Omnicam scanner. Hold the CEREC Primescan / Primescan /
CEREC Omnicam / Omnicam scanner in other places, not just on
the sleeve in order to prevent the CEREC Primescan / Primescan /
CEREC Omnicam / Omnicam scanner from falling.
4. Position the CEREC Primescan / Primescan / CEREC Omnicam /
Omnicam scanner in the holder, so that it can warm up briefly prior
to the intraoral exposure. Make sure that the holder has been
disinfected (see "Uncritical surfaces including monitor [→ 60]").
6.1.5

Cleaning the inside of the sleeve window

If you should realize during the scanning process that the inside of the
sleeve is dirty, then follow the following process:
1. Remove the sleeve from the scanner body (see "Removing the
sleeve [→ 64]") section.
2. Place the white protective sleeve on the scanner head and place
the scanner body in the scanner holder.
3. Gently tap the sleeve on a soft surface / on your hand.
4. Blow out the sleeve with compressed air.
5. NOTE! Do not moisten the inside of the sleeve window with liquid
(this can lead to marks). Clean the inside of the steel part with
ethanol or isopropanol.
Ensure that the removed impurities do not drop inside onto the
sleeve window.
Wipe the inside of the steel sleeve with a clean, dust-free and
grease-free cloth and ensure that no droplets remain.
6. Remove the scanner body from the holder and remove the white
protective sleeve.
7. Prior to inserting the sleeve, clean the scanner cone with a clean,
dust-free and grease-free cloth to remove any potential impurities/
adhesions.
8. Carefully re-attach the sleeve and allow it to lock in place (see
"Attaching the sleeve [→ 64]"). Hold the scanner in other places, not
just on the sleeve in order to prevent it from falling.
Check whether the process has had the desired effect until now.
Dentsply Sirona
67 15 481 D3696
D3696.201.01.03.02 04.2019