Software For The Scanner; Cut Out Model Areas - Dentsply Sirona CEREC Primescan AC Notice D'utilisation

Dentsply Sirona
Operating Instructions
67 15 481 D3696
D3696.201.01.03.02 04.2019

Software for the scanner

5.4
Only use software which is pre-installed on the system.
5.4.1

Cut out model areas

With the "Cut" function, you can should be able to cut out model areas.
These can be areas in which parts of cotton rolls or cheeks were
unintentionally acquired.
When performing this activity, be careful not to accidentally cut out any
areas that e.g. are located behind the model or are otherwise cut away
from the line.
ü You are now in the ACQUISITION phase.
1. Click on the Tool icon in the side palette on the right edge of the
screen.
2. Click the "Cut" button.
Ä The cursor changes to a cross.
3. Begin the cut line with a double-click.
4. Click to set additional points.
5. Finish the cut by double clicking.
Ä The model area is cut out.
6. Click the "Apply" button to implement the change.
You can execute another scan of the area which you have cut out using
the crop function. To do so, close the tool window, by clicking on the top
right corner. You can refill the area with another acquisition.
"Undo" and "Reset"
With the "Undo" button in the tools you can undo all changes made on
the selected restorations since the tool was started.
With the "Reset" button in the tools you can undo all changes made on
all restorations since the tool was started.
5 Operation
5.4 Software for the scanner
57