Intended Use - Dentsply Sirona CEREC Primescan AC Notice D'utilisation

1 General data

1.6 Intended use

10
Intended use
1.6
The CEREC Primescan AC / Primescan AC / CEREC Omnicam AC /
Omnicam AC acquisition unit creates digital impressions, which are sent
to a laboratory and/or in connection with the milling unit is used to
manufacture computer-supported dental restorations, e.g. from a
natural-appearing ceramic material. The unit may be operated only by
medically trained and qualified personnel.
This unit must not be used for any other purpose. If the unit is used for
any purpose other than the one mentioned above, it may be damaged.
Intended use also includes compliance with these Operating
Instructions and the relevant maintenance instructions.
CAUTION
Follow the instructions
If the instructions for operating the unit described in this document are
not observed, the intended protection of the user may be impaired.
Dentsply Sirona
Operating Instructions
67 15 481 D3696
D3696.201.01.03.02 04.2019