Eurosystems Minieffe 502 Mode D'emploi page 16

When you finished your work , please switch the engine off , and put the throttle handle (3) on stop position.
ADJUSTING AND CONNECTION FOR THE SCYTHING BAR: ( FIG. 7)
n
accessories , you should act on the adjusters (2) to make the bar to start scything only when the lever (4) has crossed half its way. ATTENTION !
before lowering the accessories insert lever (4) , you should always unhook the safety lever (3).
BELT-STRETCHER CONTROL ADJUSTMENT ( FIG. 8) :
n
lever (fig. 7 part. 1 ) has crossed half its way. When the mentioned lever is completely pulled, i.e. on working position , the load-belt of the belt-stretcher
(fig. 8 part. 2) should extend for 6-8 mm. To perform so you should act on the adjuster (1).
ADJUSTMENT OF THE SCYTHING BAR HEIGHT ( FIG. 9)
n
scything bar height. Please follow the instructions : Loosen the nut (1) , bring the plastic strip (2) to the needed position and tighten the nut. Please
perform the operation on both the plastic strips.
ADJUSTMENT AND REPLACEMENT FOR THE SCYTHING BLADE ( fig. 10)
n
face the possibility to adjust the scything blade . In case you need to unscrew the lock-nut (4) and adjust the set-screws (3) to eliminate the over-
clearance between upper / lower teeth.
IMPORTANT ! for the various adjustments checks you should first disassemble the cover by hand then slowly rotate the pulley (2) by hand and verify
that the blades can freely turn. Unscrew the screws (1) and take the driving bar plate out (2) . Loosen the plastic-strip (3) , the set-screw (4) and take
the blade out. In case of too much wear , it is necessary to change the plate as well (2) and the spacer-lock (5). To re-assemble the blade , please
perform the operations in the reverse order. NOTE : to obtain a good cut performance , the blade should always be sharpened.
SERVICE / GARAGING.
n
GEARBOX (fig. 11) : lubricating . Use SAE 80 . Please verify the oil level before switch the engine on. The oil level can be verified unscrewing the
cap placed on the side of the gearbox.
TRANSMISSION SCYTHING BAR ( fig. 12) : there are 2 greasing point ( 1-2) . Important : after every use of the motormower , please clean and
grease the scything bar and all motion parts/mechanisms..
ENGINE SERVICING ( please read the specific part). The motormower is delivered equipped with a 4 stroke engine , NO OIL is included. Please fill
the tank in up to the shown level ( capacity about 0,500 kg.) . Referring to the oil/viscosity type, please follow the engine producer instructions.
SCYTHING BAR SERVICING : the motormower is undoubtly one of the most used agricultural equipment and need a good and frequent servicing.
We recommend you to clean very deeply after every use. If the machine is not used for long periods it is ESSENTIAL to protect the blade and the
bar using some anticorrosive and antioxidant materials. The presence of impurities or foreign bodies on the meadow, damages the teeth sharpening
of the scything bar. It is useful to sharpen the blade and check the teeth integrity every 10 hours use, Only if you keep a good sharpening teeth level
you can obtain the best grass cut. Furthermore it is good to perform a periodical control and a possible setting up of the " clearance" of the blade in
the sliding supports.
9
to increase the belt tension between the unit and the
attention ! the motormower wheels should start to turn when the driving
if you need to scythe on uneven grounds it is necessary to adjust the
After about 10 hours work, you could probably