Parkside PWSAP 20-Li C3 Instructions D'utilisation Et Consignes De Sécurité page 56

m
CAUTION! RISK OF INJURY!
Always hold the product with both hands
u
while working (Fig. K).
Keep your hands away from the accessory
u
tool when the product is in operation.
After the product has been switched off, the
u
accessory tool continues moving for some
time. Do not touch the accessory tool and
do not attempt to brake it.
m
CAUTION! HEALTH RISK!
Never work on materials containing
u
asbestos. Asbestos is considered
carcinogenic.
L
3.
Switching on: Push the rear part of the
on/off switch down and slide it forward.
3 ] [
(Fig. L, 1&2).
Continuous operation: Tilt the front part
of the on/off switch
engages (Fig. L, 3).
Switching off: Press the rear part of the
on/off switch so that it snaps back into its
3 ] [
off position.
2.
1.
downwards until it
3 ] [
˜ Trial run
NOTE
Always carry out a no-load trial run before
u
starting work and after every accessory
tool replacement. Switch the product off
immediately if the accessory tool is not
running smoothly, if considerable vibration
occurs or if you hear abnormal noises.
˜ Working instructions
˜ Grinding
m
WARNING!
Never use a cutting disc for grinding!
u
Hold the product at a 10 to 15° angle for
easy handling and smooth grinding results.
Apply the grinding disc to the work surface
with a light, steady pressure for maximum
grinding efficiency. It should never be
necessary to force the product. The weight of
the product applies adequate pressure.
Excessive pressure will overload the motor,
slow the grinding action, put dangerous stress
on the grinding disc and causes breakage.
Move the product back and forth steadily.
GB/IE 55