Parkside PWSAP 20-Li C3 Instructions D'utilisation Et Consignes De Sécurité page 58

˜ Maintenance
Before and after each use, check the product
and accessories (e.g. accessory tools) for
wear and damage. If required, exchange
them for new ones as described in this
instruction manual. Observe the technical
requirements (see "Technical data").
˜ Repair
This product does not contain any parts
that can be repaired by the user. Contact
an authorised service centre or a similarly
qualified person to have it checked and
repaired.
˜ Storage
Switch the product off.
Clean the product as described above.
Store the product and its accessories in a
dark, dry, frost-free, well-ventilated place.
Always store the product in a place that is
inaccessible to children. The ideal long term
storage (longer than 3 months) temperature is
between +20 and +26 °C.
Store the product in its case
Cutting or grinding discs must be dry and
stored upright, and should never be stacked.
Battery pack advice
˜ Transportation
.
[ ]
Only store the battery pack
charged. The battery pack should be charged
to 40 to 60 % (red and orange LED in the
charge indicator light up) before storing
[ ]
for extended periods.
Check the battery pack
every 3 months when storing for extended
periods. Recharge as necessary.
Switch the product off.
Transport the product in its carrying case
Protect the product from any heavy impact
or strong vibrations which may occur during
transportation in vehicles.
Secure the product to prevent it from slipping
or falling over.
partially
5 ] [
charge about
5 ] [
.
[ ]
GB/IE 57