Measuring Weight Only - Beurer BG 65 Mode D'emploi

2.2 Measuring weight only

Tap the platform of your scales briefly but firmly with your foot.
Briefly touch the scale with your foot. The whole display (fig. 1) appears as an
automatic test until „0.0" (fig. 2) is displayed (tap-on technology). The scale
is now ready to measure your weight. Stand on the scale without moving
about and distribute your weight evenly on both legs. The scale immediately
starts to measure your weight.
„000" flashes until your weight has been measured (fig. 3).
Your measured weight is displayed shortly thereafter (fig. 4). The scale switches
itself off a few seconds after you step down from it.
2.3 Measuring weight and body fat and body water percentage
Your personal parameters must first be stored.
– With BG 65 you have to step briefly onto the platform (2.2) and then press
"SET". The memory places 1 to 10 now appear in the display (fig.5). Select
the desired memory place by operating the "up"
and confirm the desired memory place with the "SET"button.
– Height („Ht") in „cm" (inch) (fig. 6) now blinks in the display.
Select the correct height by either repeatedly or continuously pressing „up"
or „down" and confirm by pressing „SET".
– „Age" in years flashes in the display (fig. 7).
Select the correct age by either repeatedly or continuously pressing „up"
or „down" and confirm by pressing „SET".
– The sex setting „"Woman" or „"Man" appears on the display (fig. 8). Select the
sex by operating the "up"
memory place with "SET".
– The setting for your individual degree of activity and fitness now appears
on the display (fig. 9-11). Select the desired level of activity by operating
the "up" or "down"
with the "SET" button.
Fitness 1: No or little physical activity
(less than 20 minutes of physical exercise twice a week, e.g. going for a
walk, light gardening, gymnastic exercises)
Fitness 2: Moderate physical activity
(physical activity up to 2 – 5 times a week, 20 minutes each time, e.g. jogging,
cycling, tennis, ...)
Fitness 3: Intensive physical activity
(Daily intensive training or physical work, intensive running, construction
worker, ...)
– The values, which have now been set, are displayed once again, one after
the other. The scale then automatically turns itself off.
The scale has 10 memory spaces for basic data, where personal details, of indi-
vidual family members for example, can be stored and called up at any time.
– You have to switch on the scales first by stepping on the platform. Select
the memory place where your basic personal data are stored by pressing the
"User" button several times. The data are displayed in succession until "0.0"
appears (fig. 2).
– Step on the scales barefoot and ensure that you are standing on the two
electrodes. Your body weight is first determined and displayed as decribed
under 2.2.
– Remain standing on the scales and the body fat and body water analysis is
now performed. This can take a few seconds. During this time "bF" and "H2O"
flash alternately on the display (fig. 12 + 13).
or "down" buttons and confirm the desired
buttons and confirm the desired memory place
or "down" buttons
10
fig. 1
fig. 2
fig. 3
fig. 4
fig. 5
fig. 6
fig. 7
fig. 8
fig. 9
fig. 10