REX BX-401 E Manuel De L'utilisateur page 32

Assembly
STEP 3
STEP 4
GB-32
REX_Trainer_BX401E_13.indd GB-32 REX_Trainer_BX401E_13.indd GB-32
WARNING
1. Connect the upper computer cable to the lower com-
puter cable (64 + 65) (see Fig. b).
2. Push the handlebar support tube (17) with cover
(98) onto the main frame (1) (see Fig. a).
Make sure not to pinch the computer cable.
3. Now fasten the handlebar support tube with six Allen
screws (15) and six washers (8 + 16) to the frame.
4. Fix the drink bottle holder (63) with two screws (62)
to the handlebar support tube (17).
WARNING
1. Clamp the handlebar (36) in the handlebar locking
clamp.
2. Fix the handlebar with the cover (42) using the
locking screw (41), the washer and the spring washer
(43 + 44) as well as the spacer sleeve (45).
3. Pull the pulse sensor cable of the handlebar up
through the side holes in the handlebar support tube
(see Fig. a).
4. Connect the upper computer cable (64) and the cable
of the pulse sensors (34) to the display (76) (see
Fig. b).
5. Fix the display with four screws (99) to the handle-
bar support tube.
Assembly
15.05.13 09:09 15.05.13 09:09