Lenze 8200 motec Instructions De Montage page 75

1
Safety instructions
Lenze controllers
Safe standstill −8−
Variant V004 of the controller series 9300 and 9300 vector, variant x4x of the
controller series 8200 vector and axis module ECSxAxxx support the
function "Safe standstill", protection against unintentional restart,
according to the requirements of Appendix I, No. 1.2.7 of the EC Directive
"Machinery" 98/37/EC, DIN EN 954−1 category 3 and DIN EN 1037. It is
absolutely necessary to observe the information about the function "Safe
standstill" in the corresponding documentation and instructions.
Maintenance and service
The controllers do not require any maintenance, if the application conditions
prescribed are observed.
In operating areas with polluted ambient air, the cooling surfaces of the
controller can get dirty or the cooling openings can block. Under these
conditons a regular cleaning of the cooling surfaces and cooling openings
is essential. Do not use sharp or pointed objects for this purpose!
Disposal
Recycle metals and plastics. Dispose of printed circuit board assemblies
according to the state of the art.
The product−specific safety and application notes in these Instructions
must also be observed!
L
73
EDK82MV222 DE/EN/FR 8.0