Lenze 8200 motec Instructions De Montage page 124

7
Commissioning
The most important codes for commissioning
Code
No. Name
C0148 Motor
* parameter
s
identification
C0517 User menu
*
v
1 Memory 1
2 Memory 2
3 Memory 3
4 Memory 4
5 Memory 5
6 Memory 6
7 Memory 7
8 Memory 8
9 Memory 9
10 Memory 10
C0608 Fan
* monitoring
122
Possible settings
Lenze Selection
0
0 Ready
1 Start identification
l V/f−rated frequency (C0015), slip
compensation (C0021) and
motor stator inductivity (C0092)
are calculated and saved.
l The motor stator resistance
(C0084) = total resistance of
motor cable and motor is
measured and saved
50 C0050 Output frequency (MCTRL1−NOUT)
34 C0034 Analog setpoint selection range
7 C0007 Fixed configuration − digital input
signals
10 C0010 Minimum output frequency
11 C0011 Maximum output frequency
12 C0012 Acceleration time main setpoint
13 C0013 Deceleration time main setpoint
15 C0015 V/f rated frequency
16 C0016 U boost
min
2 C0002 Parameter set transfer
0
0 Not active
1 TRIP error message
2 Warning
EDK82MV222 DE/EN/FR 8.0
IMPORTANT
Only when the motor is cold!
1. Inhibit controller, wait until
drive is in standstill
2. Enter the correct motor data
under C0087, C0088,
C0089, C0090, C0091 (see
motor nameplate).
3. C0148 = set 1 by v
4. Enable controller
The identification
– starts, c gets out
– the motor makes a
high−pitched tone, but
does not rotate!
– takes approx. 30 s
– is completed when c is
on again
5. Controller inhibit
After mains switching or
l
when using the function
g the code from C0517/1
will be displayed.
In Lenze setting, the user
l
menu contains the most
important codes for setting
up the control mode "V/f
characteristic control with
linear characteristic"
l When the password
protection is activated, only
the codes entered under
C0517 are freely accessible.
Enter the required code
l
numbers in the subcodes.
Codes, which are only active
when being used together
with an Application−I/O,
cannot be entered!
8200 motec 3 ... 7.5 kW:
Function must be activated
during commissioning!
Otherwise, the controller may
be destroyed through
overheating.
For all other controllers:
It is essential to set C0608 = 0.
L