geo-FENNEL FHT 70 DataLog Mode D'emploi page 17

Samprate
LED flash cycle
Manual / Automatic
Alarm-Set-up
Temp Alarm Low
Temp Alarm HI
RH Alarm Low
RH Alarm HI
Unit
Circulating Record /
No Circulating
When all settings have been made press button SETUP to save the changes.
With button DEFAULT instrument can be re-set to factory settings.
Note
Any stored data will be permanently erased when Setup is finished.
In order to save the data before click CANCEL and start download of the data.
Note
Always ensure that battery power is still enough for the whole duration of the measurement intended
before you start critical measurements. Otherwise important data will be lost.
Sampling rate; data recording cycle; available settings in seconds / minutes /
hours
LED flashing cycle; LED can also be switched off (which will save battery po-
wer); available settings every 10, 20, 30 seconds
Select automatic (recording will start immediately after closing the set-up win-
dow) or manual (at later time) data recording
Setting of Low Alarm Value; LED will flash if temperature drops below this value
Setting of High Alarm Value; LED will flash if temperature exceeds this value
Setting of Low Alarm Value; LED will flash if air humidity drops below this value
Setting of High Alarm Value; LED will flash if air humidity exceeds this value
Setting of unit in which temperature measured is displayed (°C / °F)
Data logger continues recording when memo rizer is full and covers data recor-
ded earlier (Circulating Record) or recording stops when memorizer is full and
all data recorded up to this moment will be stored (No Circulating).
EN
17