Saw Blade Mounting And Dismounting - Hitachi C 12LSH Mode D'emploi

English
15. How to use the dust bag (Standard accessory)
Dust bag
Duct
CAUTION:

SAW BLADE MOUNTING AND DISMOUNTING

WARNING:
* To prevent an accident or personal injury, always turn off the trigger
* If the 10 mm bolts are attached or detached using tools other than the
1. Mounting the saw blade (Fig. 52-a, Fig. 52-b, Fig. 52-c and Fig. 52-d)
(1) Use the Phillips screwdriver to loosen the 5 mm screw fastening the spindle cover
and then turn the spindle cover.
(2) Press in spindle lock and loosen 10 mm bolt with 17 mm wrench (standard
accessory).
Since the 10 mm bolt is left-hand threaded, loosen by turning it to the right as
shown in Fig. 52-c.
NOTE:
If the spindle lock cannot be easily pressed in to lock the spindle, turn the 10
mm bolt with 17 mm wrench (standard accessory) while applying pressure
on the spindle lock.
The saw blade spindle is locked when the spindle lock is pressed inward.
38
Right angle Base surface
Fig. 51
Empty the dust bag frequently to prevent the duct and the lower
guard from becoming clogged.
Sawdust will accumulate more quickly than normal during bevel
cutting.
switch and disconnect the power plug from the receptacle before
removing or installing a saw blade.
If cutting work is done in a state where the 10 mm bolt is not sufficiently
tightened, the 10 mm bolt can get loose, the blade can come off, and
the lower guard can get damaged, resulting in injuries.
Also, check that the 10 mm bolts are properly tightened before plugging
the power plug into the receptacle.
17 mm wrench (standard accessory), excessive or improperly
tightening occurs, resulting in injury.
(1) When the dust bag has become full of
sawdust, dust will be blown out of the dust
bag when the saw blade rotates.
Check the dust bag periodically and empty
it before it becomes full.
(2) During bevel and compound cutting,
attach the dust bag at a right angle to the
base surface as shown in Fig. 51.