Applications; Preparation Before Operation - Hitachi C 12LSH Mode D'emploi

English

APPLICATIONS

Wood and aluminum sash.

PREPARATION BEFORE OPERATION

Make the following preparations before operating the power tool:
1. Installation
11/32" (9 mm)
3 holes
Attach the power tool to a level, horizontal work bench in accordance with Fig. 4.
Select 5/16" (8 mm) diameter bolts suitable in length for the thickness of the work
bench.
Bolt length should be at least 1-9/16" (40 mm) plus the thickness of the work bench.
For example, use 2-9/16" (65 mm) or larger bolts for a 1" (25 mm) thick work bench.
The holder attached to the rear of the base helps stabilize the power tool.
Adjust the holder until its bottom surface contacts
the work bench surface.
14
9-39/64" 11-1/16"
(244 mm) (281 mm)
Move
Holder
Fig. 5
Base
Work bench
Fig. 4
Holder adjustment:
Loosen the 6 mm bolt with the 10 mm
box wrench.
Adjust the holder until its bottom surface
contacts the work bench surface.
After adjustment, firmly tighten the 6
mm bolt.
6 mm
Bolt
5/16" (8mm) bolt
5/16" (8 mm) nut