Internal Noises Simulation - Key B Organ viscount Legend Mode D'emploi

To activate the percussion, use the tab [PERCUSSION ON/OFF] (Legend and Legend Classic) or the
[ON/OFF] button (Legend Live) on the PERCUSSION section of the front panel.
Percussion volume can be adjusted through the [PERCUSSION SOFT/NORM] tab (Legend and Legend
Classic) or the [SOFT/NORM] button (Legend Live).
In NORMAL mode (led off in Legend Live) volume is set through the potentiometer [PERCUSSION VOLUME].
In SOFT mode (led on in Legend Live) the volume is decreased. The potentiometer mentioned above can also
be used to finely adjust the maximum volume of the percussion.
Level
Note On
Select the percussion decay time through the tab [PERCUSSION DECAY SLOW/FAST] (Legend and Legend
Classic) or the [SLOW/FAST] button (Legend Live).
In SLOW mode (led off in Legend Live) the decay time is set by the [PERCUSSION DECAY] potentiometer.
In FAST mode (led on in Legend Live) the decay time is shorter. The potentiometer mentioned above can be
used for fine adjustment of the maximum percussion decay time.
Level
Note On
Select the percussion harmonic through the tab [PERCUSSION HARMONIC SELECTOR SECOND/THIRD]
(Legend and Legend Classic) or through the button [2nd/3rd] (Legend Live).
In SECOND mode (led off in Legend Live) the harmonic used by the percussion in the second (equivalent to a
4 'register).
In THIRD (led on in Legend Live) the percussion harmonic is a third (equivalent to a 2 2/3' register).

4.4 INTERNAL NOISES SIMULATION

The electromechanical organ sound is not only characterized by tonewheels, drawbars and percussion, but
also other noises which were initially considered flaws but that have become over time distinctive features of
this type of instrument. One of these is the click (or Keyclick) generated at the attack of the note by the switch
of each key.
Another fault that became part of the sound is the noise generated by the extreme proximity of the audio wiring
(Crosstalk), where each cable interfered with the others. Therefore, when a key was pressed, many other notes
played too, but at a much lower volume.
In order to make the sound of Legend / Legend Classic / Legend Live as faithful as
possible to the original electromechanical counterpart, you can add the Keyclick effect
and adjust its volume through the [KEYCLICK] potentiometer.
The [CROSSTALK] potentiometer adjusts the level of the noise generated by wiring
Percussion signal level
Drawbar signal level
Time
Note Off
NORMAL Percussion
Percussion signal level with
normal decay time
Drawbar signal level
Time
Note Off
SLOW Percussion
Level
Attenuated Percussion signal level
Drawbar signal level
Note On
SOFT Percussion
Level
Percussion signal level with
reduced decay time
Drawbar signal level
Note On
FAST Percussion
EN - 19
User Manual
Time
Note Off
Time
Note Off