Unit; Ball Siphon - Helios KWL EC 360 W Notice De Montage Et D'utilisation

Installation and Operating Instructions
m
WARNING
m
Mounting part with
seal elements
Locking part
Float ball
Siphon casing
Hose connector
Compact wall-mounted units – KWL EC 360 W/W ET
– Adjustment of intake air connection
If the intake air connection should be on the left side of the unit (see Fig. 6), the unit must be converted as follows:
1. Remove the panel on the front of the unit.
2. Loosen and remove the screws in the unit door and the back panel.
3. Turn unit body 180°.
4. Reattach back panel with screws.
5. Leave unit door open for further installation steps.
4 .2 Installation
4 .2 .0 Installation steps UNIT:
1. Install enclosed wall rail horizontally on the wall (see Fig. 7 and 8).
m
Risk of injury due to the high weight of the unit!
The unit can fall down and cause serious injuries when lifting.
The heat exchanger can fall down and cause serious injuries when removed .
> Carefully remove the heat exchanger from the unit with both hands .
> Move unit with at least 2 persons.
2. Remove the heat exchanger from the unit to reduce the weight (see Fig. 9).
3. Hang the unit mounting bracket on the wall rail (s. Abb. 10).
4. Ensure that the unit is fixed to the wall.
4 .2 .1 Installation steps BALL SIPHON:
During heating periods, condensate may form in the heat exchanger due to the heat recovery process. The condensate
must be able to drain freely from the unit. The provided ball siphon (scope of delivery) must be installed in the base tray
of the unit for this purpose:
1. Open ball siphon, turn the mounting part a 1/4 turn (Fig. 11).
2. Plug the mounting part in the condensation outlet from below, until the claw fasteners snap to the sheet edge of the
base plate (Fig. 12).
3. Insert locking part and insert up to stop (Fig. 13).
Fig .7
Mounting rail
Fig .9
Fig .11
7
Wall rail
View below View above
EN
Fig .8
Fig .10
KWL unit
Fig .12