Use Of The Fryer; Control Panel; Switch On Of The Control Panel; Wait For Input - Idle Modus - FriFri Vision Manuel D'installation

5 Use of the fryer

5.1 Control panel

« Quick Access »
5.2 Switch on of the control panels
5.3 Wait for input – Idle Modus
This screen indicates that the control panels is waiting for further input. From this postion on you can choose:
Remark: Its possible to set an automatic switch into the FMC mode by setting a time frame for the "Idle" modus.
See programming of the "Service Mode".
buttons
The „Reset" button initialize the safety thermostat.
The red LED indicates that the safety curcuit is active.
With the „On" button the control panel gets under tension.
The green LED indicates that the control paenl is now ready for further input.
The „Off" button shut down completely the control panel.
.
Digital display
a) Selcet the programming mode
Keep the „P" button pressed for three seconds
b) Start the optional oil pump
A touch on the „Pump" button starts the pump
process.
c) Start the fat melting cycle (FMC)
By a touch of the "P" button
d) Select a frying program
By a touch on a "Quick Access" button
Confirm / start
ON/OFF
Button
button
Selection
buttons
Pump
Button
Reset safety
thermostat