Important Information; Safety - TechniSat DIGITRADIO 143 CD Mode D'emploi

Masquer les pouces Voir aussi pour DIGITRADIO 143 CD:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 58

1 Important information

Please take note of the following information to minimise safety risks, to prevent damage to the device and to make a
contribution to environmental protection. Please read all the safety information carefully and keep it for future reference. Always
observe all warnings and information in this quick start guide and on the rear of the device.
Caution - This identifies important information that must be observed to prevent device defects, data loss/misuse or
undesired operation.
Tip - This identifies information relating to the described function, as well as to another related function that may have to
be taken into account, with reference to the corresponding section in the manual.

1.1 Safety

For your own protection you should read the safety notes carefully before using your DIGITRADIO 143 CD. The
manufacturer accepts no liability for damage caused by improper handling and by not observing the following safety
precautions:
-
Never open the device! Touching live parts can be fatal!
-
Any required intervention may only be performed by qualified staff.
-
The device must only be operated in an appropriate climate.
-
In the event of extended transport in the cold and a subsequent change to warm rooms, do not switch on immediately;
wait for the temperature to equalise.
-
Do not expose the device to dripping or splashing water. If water has penetrated the device, switch it off and inform the
Service department
-
Do not expose the device to heat sources which could heat it up more than normal use will.
-
In a thunderstorm, disconnect the device from the mains. Overvoltage can damage the device.
-
If you detect a device defect, odour or smoke, a major malfunction, or damage to the housing, switch off the device and
inform the Service department.
-
The device must only be connected to a mains voltage of 100V-240V~, 50/60 Hz. Never try to operate the device at any
another voltage.
-
The device must not be connected until the installation has been completed according to regulations.
8

Publicité

Table des Matières
loading

Table des Matières