Configuration Via The Wps Function; Manual Configuration - TechniSat DIGITRADIO 143 CD Mode D'emploi

The entered password is now verified. This process is generally completed in a few seconds and the WLAN connection
can now be used.

14.2.2.2 Configuration via the WPS function

This establishes a direct connection to the router. Selecting and/or entering a WLAN network (SSID) and password is not
required.
> Start the WPS function on your router as per the instruction manual.
> Then select [PBC WLAN structure] to launch the connection process.
Please observe the display overlays. The connection process is generally completed in a few seconds and the WLAN
connection can be used.

14.2.2.3 Manual configuration

> Select [Manual settings] then [Wireless] to launch manual configuration.
> Now select whether to allow automatic retrieval of the IP address, gateway etc. from your router (DHCP active) or if you
would like to enter this manually (DHCP inactive).
Please take into account that automatic retrieval of the IP address, gateway, subnet mask only works if the DHCP function
is activated in your router.
> One by one, enter the IP address, subnet mask, gateway address, primary DNS and secondary DNS if required, using the
Arrow buttons on the remote control. Confirm each set value with the OK button.
> Now enter the name (SSID) of your WLAN network using the virtual keyboard and confirm with OK.
> Select whether your WLAN network is Open, encrypted by WEP or by WPA/WPA2 and confirm the following item.
> Continue to use the virtual keyboard to enter your WLAN password and confirm with OK to start the connection process.
In general, the WLAN connection can be used after a few seconds.
EN
FR
IT
NL
PL
CZ
SK
45