Switching Off/Deactivating The Alarm; Switching On/Activating The Alarm; Using Headphones; System Settings - TechniSat DIGITRADIO 143 CD Mode D'emploi

13.2.3 Switching off/deactivating the alarm

> As described under 13.2.1, select the alarm memory (Alarm 1 or Alarm 2) you wish to switch off/deactivate.
> Open [Repeat] and set this to [Off], to deactivate the alarm.
The alarm settings are not accepted until selecting [Save].
The alarm settings are retained so that this can be easily switched on/activated again at a later date.

13.2.4 Switching on/activating the alarm

> Select the alarm memory (Alarm 1 or Alarm 2) you wish to switch on/activate.
> Open [Repeat] and set this to Daily, Once, Weekend, or Working days to activate the alarm with the settings already
available (See Section 13.2.1).
If required you can adjust the other settings as described in Section 13.2.1.
The alarm settings are not accepted until selecting [Save].

13.3 Using headphones

Do not listen to music at a high volume when using headphones. Doing so can cause permanent hearing impairment. Turn
down the radio volume to the lowest volume before using headphones.
> Only use headphones with a 3.5 mm jack plug.
> Insert the headphone connector in the headphone socket (12) on the front of the DIGITRADIO.
When the headphones are connected, the sound is played via the headphones and the audio outputs at the same time.
Volume adjustment also occurs in parallel.

14 System settings

The system settings are equally applicable to all sources.
> To access the system settings, press the MENU button and select > System settings.
42