Manual Configuration; Connection Via Wlan; Network Wizard Configuration - TechniSat DIGITRADIO 143 CD Mode D'emploi

14.2.1.2 Manual configuration

> Select [Manual settings] and then [Cable] to start manual configuration.
> Now select whether to allow automatic retrieval of the IP address, gateway etc. from your router (DHCP active) or if you
would like to enter this manually (DHCP inactive).
Please take into account that automatic retrieval of the IP address, gateway, subnet mask etc. only functions if the DHCP
function in the router is activated.
> One by one, enter the IP address, subnet mask, gateway address, primary DNS and secondary DNS if required, using the
Arrow buttons on the remote control. Confirm each set value with the OK button.

14.2.2 Connection via WLAN

To configure the network connection via WLAN, you have the option of using the network wizard or doing so manually.

14.2.2.1 Network wizard configuration

> Select [Network wizard] to launch this.
The network wizard now searches for all the WLAN networks within range and displays them to you.
> Then select your WLAN network.
You can now choose whether to use the WPS function or whether you prefer to enter your WLAN password manually.
> If you would like to use the WPS function, launch it on your router as per the instruction manual and then select [Press
button] in the network wizard.
Please observe the display overlays. The connection process is generally completed in a few seconds and the WLAN
connection can be used.
> If you wish to enter your WLAN password manually, or if your router does not support the WPS function, select [Skip
WPS].
> Then enter your WLAN password using the virtual keyboard display and confirm your selection with OK.
44