Storing The String Trimmer - Ryobi CLT1830B Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
GB
F
D
E
Press in the tabs on each side of the spool cap.
Q
Remove the spool cap and spool.
Q
NOTE: If the spring falls off the spool housing during
this procedure, reinstall the spring before installing
the spool and spool cap.
Inspect the string head for damaged or worn parts
Q
and clean thoroughly.
Unwind approximately 102 mm (4 in.) of the line from
Q
the prewound spool. Hold the line and spool firmly to
keep it from unwinding then place the spool cap onto
the spool.
Holding the spool cap and spool by the bump knob,
Q
place into the spool housing and insert cutting line
into the opening in spool housing.
NOTE: Tabs on the spool cap should be aligned with
the slots in the spool housing.
While pressing in the tabs, push down the spool cap
Q
and spool to lock in place.
Completely assembled string head should appear as
Q
shown. See Figure 15.
WARNING
Do not attempt to modify this unit or create
or mount any accessory not specifically
recommended in this manual for use with
this string trimmer. Any such alteration or
modification is misuse and could result in a
hazardous condition leading to possible serious
personal injury. Examine string trimmer frequently
to assure all parts are unbroken and securely
attached. Make sure all screws and fasteners are
securely tightened to prevent the risk of serious
personal injury.
CLEANING THE STRING TRIMMER
Remove the battery pack.
Q
WARNING
To prevent serious personal injury, remove
the battery pack before servicing, cleaning,
or removing material from the unit.
Clean the unit using a damp cloth with a mild
Q
detergent.
Do not use any strong detergents on the plastic
Q
housing or the handle. They can be damaged by
certain aromatic oils such as pine and lemon, and by
solvents such as kerosene.
Moisture can cause a shock hazard. Wipe off any
Q
moisture with a soft dry cloth. Use a small brush or
the air discharge of a small vacuum cleaner brush to
clean the air vents on the battery pack housing and
motor housing.
Keep the air vents free of obstructions.
Q
I
P
NL
S
DK
N
FIN GR HU
CZ RU
English

STORING THE STRING TRIMMER

Clean the string trimmer thoroughly before storing.
Q
Store the string trimmer in a dry, well ventilated place
that is inaccessible to children. Keep away from
corrosive agents such as garden chemicals and
de-icing salts.
Store and charge your batteries in a cool area.
Q
Temperatures above or below normal room
temperature will shorten battery pack life.
Never store batteries in a discharged condition.
Q
Wait for battery pack to cool and charge immediately.
All batteries gradually lose their charge. The higher
Q
the temperature, the quicker they lose their charge.
If you store your unit for long periods of time without
using it, recharge the batteries every month or two.
This practice will prolong battery pack live.
DISPOSAL
Waste electrical products should not be disposed of
together with household waste. Please recycle where
facilities exist. Check with your local authority or retailer
for recycling advice.
17
RO PL SLO HR TR EST LT
LV
SK BG

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Clt1830pClt1830lbClt1830lc

Table des Matières