Reely Dart Notice D'emploi page 38

The drive battery in the vehicle is not only used for power supply of the engine via the speed controller.
The speed controller also generates the voltage/current required for operating the receiver and the steering
servo.
For this, the speed controller has an integrated BEC ("Battery Eliminator Circuit"; electronic circuit for direct
voltage supply of the receiver without additional receiver battery).
If the voltage in the drive battery is too low, the voltage at the receiver may also drop, causing the vehicle to
no longer respond to the control commands at the transmitter.
In this case, stop driving at once (switch off speed controller, disconnect drive battery from vehicle, switch off trans-
mitter). Then replace the vehicle drive battery or recharge the drive battery.
• The motor and drive as well as speed controller and drive battery of the vehicle get hot during operation. Wait at
least 5 to 10 minutes before exchanging the rechargeable battery and any new driving cycle.
Let the drive battery cool down completely before charging it.
Do not touch the motor, the speed controller or the rechargeable drive battery until they have cooled down. Danger
of burns!
38