Reely Piper J3 Cub Notice D'emploi page 52

Motor Function
Attention!
Ensure that no loose parts, such as paper, film or other objects can be sucked into the rotor during this
motor test. Also make sure that the model is held securely during this test run and that no clothing and
body parts are within the rotation range or danger area of the rotor.
• Slide the control lever for the engine speed (also see figure 2, item 4 or 12, depending on mode set) to the bottom
position (engine off).
• Start up the transmitter and then the model.
• Push the control lever for the motor function slowly from the bottom to the top position. The rotor will start up and
increase speed depending on control lever position.
• When the control lever is at the top stop, the maximum rotor speed is reached. Then move the control lever back to
the bottom-most position.
• Perform a brief engine test and check the run of the propeller and the propeller catch.
• Disconnect the flight battery from the model and switch off the transmitter.
52