Ryobi RBC-52SB Manuel D'utilisation page 22

GB
F D E
SPECIFICATIONS
Engine displacement
RBC-52SB
RBC-40SB
Maximum engine performance
(in accordance with ISO 8893)
RBC-52SB
RBC-40SB
Maximum rotational frequency
of the the spindle
Engine speed (rotational frequency)
at recommended max. spindle
rotational frequency
Engine speed (rotational frequency)
at idle
Fuel consumption (in accordance
with ISO 8893) at max.
engine performance
Specific fuel consumption
(in accordance with ISO 8893)
at max. engine performance
Vibration level idling
- Left handle
- Right handle
Vibration level racing
- Left handle
- Right handle
Sound pressure level
(in accordance with EN ISO 11806:
1997, ISO 7917:1987)
Sound power level
(in accordance with ISO 10884)
DESCRIPTION
1. M6 wrench
2. Hole of the gear case
3. Hole in the upper flange washer
4. Upper flange washer
5. Blade cover
6. Blade
7. Cupped washer
8. Washer
9. Blade nut
10. Gear case
11. Spark plug wrench
12. String head
13. Connector
14. Grass deflector
15. Screw for grass deflector
16. Locking tab
17. Notch
I P NL S DK
51.7 cm
40 cm
1.4 kW / 1.9 HP
1.27 kW / 1.7 HP
10000 min-
12500 min-
2250-2750 min-
0.85 kg/h
0.45 kg/h
7.3 m/s
7.5 m/s
7.2 m/s
7.5 m/s
102 LpA (dBA)
115 LwA (dBpA)
N FIN GR HU CZ RU
English
18. Handle bar
19. Bottom clamp
20. Shaft
3
21. Throttle trigger
3
22. Top clamp
23. Latch
24. Strap hanger
25. Quick release tap
26. Mounting bracket
1
27. Best cutting area
28. Dangerous cutting area
29. Ignition switch
1
30. Primer bulb
1
31. Lever
32. Blade protector
33. Filter
ASSEMBLY
HANDLE (Fig. 2)
2
Place the handle bar (18) in the bottom clamp (19)
■
2
located on the shaft (20) housing.
Note: The throttle trigger (21) must be mounted to the
2
operator's right side.
2
Place the top clamp (22) on top and tighten the four
■
M5 x 25 screws.
Adjust the handle bar for best operator control in a
■
comfortable upright position.
ATTACHING THE SHOULDER STRAP (Fig. 3)
Connect the latch (23) on the shoulder strap to the
■
strap hanger (24).
Adjust the shoulder strap hanger to a balanced
■
position where the blade or cutter attachment will
suspend between 100 mm to 300 mm above the
ground surface.
Adjust the strap hanger to a comfortable position.
■
Note: To quickly release the product from the
shoulder strap, sharply pull the quick release tab (25).
GRASS DEFLECTOR AND BLADE GUARD USE
(Fig. 4)
Note: When converting from brushcutter to string trimmer
or string trimmer to brushcutter, make sure the correct
guard/deflector is being used.
BLADE GUARD (Fig. 5)
Attach the blade guard to the mounting bracket (26);
■
install the four screws (M5 x 16) from the bottom of
the blade guard through the mounting plate and into
the mounting bracket.
21
RO PL SLO HR TR EST LT LV SK BG