sylber Quadra ie m Manuel D'installation Et D'utilisation page 18

I.
There is a LED on the control panel, previously
described as the "Boiler status LED", which changes
colour depending on the operating status of the
appliance: green LED, red LED, yellow LED.
Green LED
- Flashing 1 second on - 5 seconds off = boiler on stand-
by, no flame.
- Flashing 0,5 seconds on – 0,5 seconds off = appliance
temporarily stopped due to the automatically resettable
faults
In this phase, the boiler waits for operating conditions
to be reset. If the boiler does not start working
properly after the waiting time has elapsed, it stops
permanently and the red LED lights up.
- Rapid flashing with brief visualisation, access to the
S.A.R.A. (Automatic Ambient Adjustment System)
function.
- A fixed green light indicates that the flame is present
and the boiler is working correctly.
Red LED
The red led shows that the boiler is blocked by a fault.
Turn the programme selector to
wait for 5-6 seconds and then turn it to the desired
position: summer or winter
Call in the your local Service Centre if you fail to unblock it.
Yellow LED
Steady = problem with hot water NTC gauge. Only
displayed when boiler in stand-by.
The boiler is working normally, but cannot guarantee a
regular hot water temperature.
Call in the Servicing Centre to have a check.
Flashing = "chimney sweep" programme working.
LED'S
to start up again,
18
Boiler status LED
Fig. 5
S.A.R.A.
function
Fig. 6