Connecting With A Vcr/15K Rgb/Component Equipment - Sony VPL-PX20 Mode D'emploi

Using USB equipment (e.g., USB mouse)
Connect the USB equipment to the USB connector on
the connector panel.
You can connect your computer to the projector via
the RGB connector, 5BNC connector or DIGITAL
RGB connector. (The example below uses the RGB
connector.)
DIGITAL
RGB RGB
Right side
5BNC
REMOTE CONTROL S
IN
RS-232C
PLUG IN POWER
OUTPUT
MONITOR AUDIO
INPUT A
DIGITAL
RGB RGB
5BNC
USB
DIGITAL RGB R/R-Y/P
R
USB
cable A
type-B
type
(sup-
plied)
Other USB
equipment
to USB to
port monitor
out
Computer
Note
Set the DIGITAL RGB/5BNC/RGB switch to the
suitable position depending on the connection.
Notes
• Your computer may not start correctly when it has
been connected to the USB connector on the
projector via the USB cable. In this case, first
disconnect the USB cable, restart the computer, then
connect the computer to the projector using the USB
cable supplied with the projector.
• The USB connector on this projector will function
only with a computer operated with Windows 98.
• When you connect the mouse to your computer via
the USB connector, do not connect another mouse to
the MOUSE port. The projector automatically
assumes that a USB mouse is connected.
VIDEO IN
L R
(MONO)
S VIDEO VIDEO AUDIO
INPUT B
RGB AUDIO MOUSE
RGB AUDIO MOUSE
G/Y B/B-Y/P SYNC/HD VD
B
Stereo audio
connecting
cable (not
supplied)
HD D-sub
15-pin
cable
(supplied)
to audio
out
USB hub function
If you connect the projector and your computer using
the USB cable for the first time, the following devices
will be recognized.
1 General purpose USB hub
2 USB human interface device (for wireless mouse
function)
3 USB human interface device (for projector control
function)
Any other devices connected to the downstream
connector of a projector are recognized by your
computer.
Connecting with a VCR/15k RGB/
Component Equipment
This section describes how to connect the projector
with a VCR, external active speakers, and 15k RGB/
component equipment.
Also refer to the instruction manuals of the equipment
to be connected.
When making connections, be sure to:
• turn off all equipment before making any
connections.
• use the proper cables for each connection.
• insert the plugs of the cables properly; plugs that are
not fully inserted often generate noise. When pulling
out a cable, be sure to pull it out from the plug, not
the cable itself.
Right side
REMOTE CONTROL S
IN
RS-232C
PLUG IN POWER
OUTPUT
MONITOR AUDIO
INPUT A
DIGITAL
RGB RGB
5BNC
USB
DIGITAL RGB R/R-Y/P
R
S-Video cable
(not supplied)
to S video
output
Active speakers
Connecting
VIDEO IN
L
R
(MONO)
S VIDEO VIDEO AUDIO
INPUT B
RGB AUDIO MOUSE
RGB AUDIO MOUSE
G/Y B/B-Y/P SYNC/HD VD
B
Audio/video
cable
(supplied)
to audio/video
outputs
VCR
17
(GB)