Connecting With A Vcr/15K Rgb/Component Equipment - Sony VPL-PX32 Mode D'emploi

Connecting / Selecting the Menu Language
Notes
• As the projector recognizes the USB mouse when the
computer is connected to the USB connector, do not
connect anything to the MOUSE connector.
• Your computer may not start correctly when
connected to the projector via the USB cable. In this
case, disconnect the USB cable, restart the computer,
then connect the computer to the projector using the
USB cable.
• This projector is not guaranteed for suspend, standby
mode. When you use the projector in suspend,
standby mode, disconnect the projector from the
USB port on the computer.
• Operations are not guaranteed for all the
recommended computer environments.
Connecting with a VCR/15k RGB/
Component Equipment
This section describes how to connect the projector
with a VCR, external active speakers, and 15k RGB/
component equipment.
Also refer to the instruction manuals of the equipment
to be connected.
When making connections, be sure to:
• turn off all equipment before making any
connections.
• use the proper cables for each connection.
• insert the plugs of the cables properly; plugs that are
not fully inserted often generate noise. When pulling
out a cable, be sure to pull it out from the plug, not
the cable itself.
Right side
REMOTE CONTROL S
IN
RS-232C
PLUG IN POWER
OUTPUT
MONITOR AUDIO
INPUT A
DIGITAL
RGB RGB
5BNC
USB
DIGITAL RGB R/R-Y/P
R
S-Video cable
(not supplied)
to S video
output
Active speakers
18
(GB)
VIDEO IN
L R
(MONO)
S VIDEO VIDEO AUDIO
INPUT B
RGB AUDIO MOUSE
RGB AUDIO MOUSE
G/Y B/B-Y/P SYNC/HD VD
B
Audio/video
cable
(not supplied)
to audio/video
outputs
VCR
Right side
DIGITAL
RGB RGB
5BNC
REMOTE CONTROL S VIDEO IN
IN
RS-232C
PLUG IN POWER
OUTPUT INPUT B
MONITOR AUDIO
INPUT A
DIGITAL
RGB RGB
5BNC
USB
DIGITAL RGB R/R-Y/P
R
BNC Cable
(not supplied)
to RGB/
component
output
15k RGB/Component equipment
Notes
• Set the aspect ratio using ASPECT in the INPUT
SETTING menu according to the input signal.
• To connect a 15k RGB/Component equipment,
select the COMPUTER/COMPONENT/DTV
YP P /DTV GBR in the INPUT-A in the SET
B R
SETTING menu according to the input signal.
• Use the composite sync signal when you input the
external sync signal from 15k RGB/component
equipment.
Connecting to a HDTV 1035/60i
Since the screen ratio of a high definition image is
16:9 and 576 lines are displayed in the vertical
direction, the image displayed is not a high-
definition image.
L R
(MONO)
S VIDEO VIDEO AUDIO
RGB AUDIO MOUSE
RGB AUDIO MOUSE
G/Y B/B-Y/P SYNC/HD VD
B
Stereo audio
connecting cable
(not supplied)
to
audio
output