Sony VPL-PX32 Mode D'emploi page 17

Using the DIGITAL RGB (TMDS)
connector
Connect the computer to the DIGITAL RGB (TMDS)
connector on the connector panel.
DIGITAL
RGB RGB
Right side
5BNC
REMOTE CONTROL S
RS-232C
PLUG IN POWER
OUTPUT
MONITOR AUDIO
INPUT A
DIGITAL
Remote
RGB
cable
USB
DIGITAL RGB R/R-Y/P
to
RS-232C
port
Digital signal
cable
SMF-D102
(not supplied)
or
SMF-D110
Computer
(not supplied)
to digital
RGB out
Computer
Notes
• Use the proper mouse cable for your computer.
• You can use a USB mouse. For details, see
"Using USB equipment (e.g., USB mouse)".
• Set the DIGITAL RGB/5BNC/RGB switch to
DIGITAL RGB (left).
• To connect digital RGB equipment, use the digital
signal cable (SMF-D102 or SMF-D110) (not
supplied). Do not use other cables — noise may
appear on the image.
Note
If you use the DIGITAL RGB (TMDS) connector, the
MONITOR connector will not output image signals.
.........................................................................................................................................................................................................
1) Windows is registered trademark of Microsoft Corporation (U.S.A. and other countries).
VIDEO IN
L R
(MONO)
IN
S VIDEO VIDEO AUDIO
INPUT B
RGB AUDIO MOUSE
RGB
5BNC
RGB AUDIO MOUSE
G/Y B/B-Y/P SYNC/HD VD
R B
Mouse cable
Stereo audio
connecting
cable (not
supplied)*
* Use a no-resistance
connecting cable.
to mouse
to audio
port
out
Using USB equipment (e.g., USB mouse)
Connect the USB equipment to the USB connector on
the connector panel.
You can connect your computer to the projector via
the RGB connector, 5BNC connector or DIGITAL
RGB connector. (The example below uses the RGB
connector.)
DIGITAL
RGB RGB
Right side
5BNC
REMOTE CONTROL S
IN
RS-232C
PLUG IN POWER
OUTPUT
MONITOR AUDIO
INPUT A
DIGITAL
RGB RGB
5BNC
USB
DIGITAL RGB R/R-Y/P
R
USB
cable A
type-B
type
(sup-
plied)
Other USB
equipment
to USB to
port monitor
out
Computer
Note
Set the DIGITAL RGB/5BNC/RGB switch to the
suitable position depending on the connection.
On the USB function
When connecting the projector to a computer by
using the USB cable for the first time, the computer
recognizes the following devices automatically.
1 USB hub (general use)
2 USB human interface device (wireless mouse
function)
3 USB human interface device (projector control
function)
The computer also recognizes the device connected
to the downstream connector on the projector.
Recommended operating environment
When you use the USB function, connect your
computer as illustrated above. The USB function can
be used on a computer loaded with Windows
Windows 98 SE or Windows 2000 preinstall models.
Connecting
VIDEO IN
L R
(MONO)
S VIDEO VIDEO AUDIO
INPUT B
RGB AUDIO MOUSE
RGB AUDIO MOUSE
G/Y B/B-Y/P SYNC/HD VD
B
Stereo audio
connecting cable
(not supplied)*
* Use a no-resistance
connecting cable.
HD D-sub
15-pin
cable
(supplied)
to audio
out
1) 98,
17
(GB)