Channel Scan (Tk-760G/ Tk-860G Only); Priority Scan; Channel Lockout; Revert Channel - Kenwood TK-760G Série Mode D'emploi

CHANNEL SCAN (TK-760G/ TK-860G only)

Scan is useful for monitoring signals on the transceiver channels. When
scanning, the transceiver checks for a signal on each channel, and only stops on
a channel if a signal is present.
The transceiver will remain on a busy channel until the signal is no longer
present. Your dealer programs the delay time between signal drop-out and scan
resumption. If a signal is received during the delay time, the transceiver will
remain on the same channel.
Note:
You can only use Scan if your dealer has programmed at least 2 channels on the transceiver. Also,
there must be at least 2 channels not locked out of Scan.
Ask your dealer for an explanation on how Channel Scan functions when using Code Squelch,
Selective Call, or 2-Tone signalling.
To start scanning, press the key programmed as Scan.
• Scanning starts from the current channel and ascends through the channel numbers.
• The SCN icon and "SCAN" appear on the display.
To end Scan, press the Scan key again.

PRIORITY SCAN

If your dealer set up a priority channel on your transceiver, the transceiver will
continuously monitor that channel while receiving a signal on another channel.
When a signal is received on the Priority channel, the transceiver immediately
switches to that channel. ("P" appears on the display.)
The transceiver remains on the Priority channel until the signal drops out. Your
dealer programs the delay time between signal drop-out and scan resumption.

CHANNEL LOCKOUT

If programmed by your dealer, you can select channels to lock out of the
scanning sequence. Perform the following steps while not in Scan mode.
1 Use the keys programmed as Channel Up and Channel Down to select the
channel you want to lock out of Scan.
2 Press the key programmed as Scan Del/Add.
• Each press of Scan Del/Add toggles the lockout status of the selected channel.
• Channels that are included in Scan are represented by an "A" on the display.
Channels locked out of Scan do not have an "A" on the display.

REVERT CHANNEL

During Scan, pressing the PTT switch to transmit will cause the transceiver to
select the revert channel. Your dealer programs the Revert channel for your
transceiver. Consult your dealer for details.
11