Code Squelch; Receiving; Transmitting - Kenwood TK-760G Série Mode D'emploi

Code Squelch is enabled or disabled by your dealer. This function turns the
transceiver squelch OFF only when it receives the DTMF code that has been set
up in your transceiver. Transceivers that do not transmit the correct code will not
be heard. Consequently, you can communicate with a specific party without
listening to other parties using the same channel.
Your dealer may also activate Group Call for your transceiver. This is useful
when you want to send information to a number of units in a fleet. Ask your
dealer for details.
Note: Code Squelch cannot be used on channels programmed with Selective Call or 2-Tone Signalling.

RECEIVING

When you receive a signal containing the correct code, squelch turns OFF and
you will hear the call.
• "CALL" appears on the display and the LED indicator flashes orange.
• To mute the speaker after squelch turns OFF, press the key programmed as Monitor.
• Your dealer can program squelch to automatically turn back ON after a specific time period
elapses.
• If Transpond for Code Squelch is programmed, an acknowledgment signal is returned to
the calling station. Transpond does not function when you are called with a Group code.
Transpond for Code Squelch can send an alert tone, a transceiver ID code, or a code
stored in memory location 1.
• If Call Alert for Code Squelch is programmed, an alert tone will sound when the correct
code is received.

TRANSMITTING

1 Press and hold the PTT switch.
2 Enter the code of the transceiver you want to call or enter a Group code on
the keypad.
• If desired, you can send codes the same way you make DTMF calls {page 12}. Both
manual methods can be used or you can store codes in memory, then dial them from a
memory location.
• "CALL" appears on the display and the LED indicator lights red.
3 Use the transceiver the same as in a regular call; press the PTT switch to
transmit and release it to receive.
• The called transceiver's squelch will turn OFF while you are transmitting. After you
stop transmitting, the squelch will turn back ON after a pre-set time period elapses.
This time period is programmed by your dealer.
• When you release the PTT switch, squelch turns OFF and the LED indicator flashes
orange (depending on dealer programming). When you receive a signal, the LED
indicator alternates between green and orange. When the signal drops out, the LED
indicator flashes orange again. If no signal is received for a pre-determined time,
squelch turns back ON.
• Pressing the key programmed as Monitor at any time will turn the squelch back ON.
14

CODE SQUELCH