Installing The Transceiver - Kenwood TK-760G Série Mode D'emploi

INSTALLING THE TRANSCEIVER

FOR PASSENGER SAFETY, INSTALL THE TRANSCEIVER SECURELY, USING THE
SUPPLIED MOUNTING BRACKET, SO THE TRANSCEIVER WILL NOT BREAK LOOSE IN
THE EVENT OF A COLLISION.
1 Mark the position of the holes in the dash, using the mounting bracket as a
template. Drill the holes, then attach the mounting bracket using the 4
supplied 5 x 16 mm screws, the spring washers, and the flat washers.
• Be sure to mount the transceiver in a location where the controls are within easy reach
of the user, and where there is sufficient space at the rear of the transceiver for cable
connections.
2 Connect the antenna and the supplied power cable to the transceiver.
3 Slide the transceiver into the mounting bracket and secure it using the 4
supplied hex-headed screws.
4 Mount the microphone hanger, using the 3 supplied 4 x 16 mm screws, in a
location where it will be within easy reach of the user.
• The microphone and microphone cable should be mounted in a place where they will
not interfere with the safe operation of the vehicle.
5 Connect the optional microphone to the microphone jack on the front panel of
the transceiver. Place the microphone on the hanger.
WHEN REPLACING THE FUSE IN THE DC POWER CABLE, BE SURE TO REPLACE IT
WITH A FUSE OF THE SAME VALUE. NEVER REPLACE A FUSE WITH A FUSE THAT HAS
A HIGHER VALUE.
4 x 16 mm self-tapping screw
Microphone hanger
Power input connector
DC power cable
* The above diagram shows the M market transceiver. The antenna connector of the E market
transceiver is different. A market code (M or E) can be found on the label attached to the package box.
Flat washer
Spring washer
Optional KMC-30
speaker/ microphone
5 x 16 mm
self-tapping screw
Antenna
Hex-headed screw
connector
12 V vehicle
battery
Mounting bracket
3