Monitor; Beginning/ End Of Transmission Signal; Public Address (Pa); Aux - Kenwood TK-760G Série Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

MONITOR

Your dealer can program a key with the Monitor function one of four ways:
A Press and hold the Monitor key to hear background noise. Release the key to return to
normal operation.
B Momentarily press the Monitor key to hear background noise. Press the key again to
return to normal operation.
C Press and hold the Monitor key to deactivate QT, DQT, DTMF, or 2-Tone signalling.
Release the key to return to normal operation.
D Momentarily press the Monitor key to deactivate QT, DQT, DTMF, or 2-Tone signalling.
Press the key again to return to normal operation.
You can use the Monitor key to listen to weak signals that you cannot hear
during normal operation and to adjust the volume when no signals are present
on your selected channel.
BEGINNING/ END OF TRANSMISSION ID SIGNAL
Your dealer can enable or disable the Beginning/ End of Transmission
identification signals. These signals are used to access and release some
repeaters and telephone systems. Ask your dealer which method has been set
up on your transceiver.
To send a Beginning of Transmission ID SIGNAL, either press the PTT switch, or
press the
key two times.
To send an End of Transmission ID SIGNAL, either release the PTT switch or
press the
key followed by the # key.

PUBLIC ADDRESS (PA)

To use the Public Address system, your dealer must install the optional PA unit
(KAP-1) and an external speaker. This function causes all audio input via the
microphone to be amplified and output from the external speaker.
To use the PA system:
1 Press the key programmed as Public Address.
2 Press the PTT switch, then speak into the microphone.
• Use the Volume Up and Volume Down keys to adjust the audio output from the
external speaker.
3 To return to normal operation, press the Public Address key again.

AUX

A control port has been provided on this transceiver for an external board. Press
the key programmed as AUX to activate or deactivate the AUX port.
19

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Tk-762g sérieTk-860g sérieTk-862g série

Table des Matières