Confirming Stored Dtmf Numbers; Dialling Stored Dtmf Numbers; Clearing Stored Dtmf Numbers; Redialling - Kenwood TK-760G Série Mode D'emploi

CONFIRMING STORED DTMF NUMBERS

To confirm the numbers stored in memory locations:
1 Press the microphone
• "A" appears on the display.
2 Enter the desired memory location number (1 ~ 9).
• TK-760G/ TK-860G only: The stored digits are displayed.
• If programmed by your dealer, no DTMF tone will sound when "D" is transmitted. "D" is
used for a pause time. The pause duration is programmed by your dealer.
3 Press any key other than the PTT switch to exit.

DIALLING STORED DTMF NUMBERS

To call a number stored in a memory location:
1 Press the microphone
• "A" appears on the display.
2 Enter the desired memory location number (1 ~ 9).
• TK-760G/ TK-860G only: The stored digits are displayed.
3 Press the PTT switch.
• If programmed by your dealer, no DTMF tone will sound when "D" is transmitted. "D" is
used for a pause time. The pause duration is programmed by your dealer.

CLEARING STORED DTMF NUMBERS

To clear the numbers from a memory location:
1 Press the microphone # key twice.
• "D- CLR" appears on the display.
• To cancel the process, press any key other than 1 ~ 9.
2 Enter the desired memory location number (1 ~ 9).

REDIALLING

You can redial the last number you transmitted (16 digits maximum).
1 Press the microphone
programmed onto a key, simply press the Redial key.
• "A" appears.
• TK-760G/ TK-860G only: The digits are displayed as well.
2 Press the PTT switch.
Note: Switching OFF the transceiver power clears the redial memory.
key.
key.
key, then press the 0 key. Or, if Redial has been
13