Fcc Compliance Information - Beurer BC 21 Mode D'emploi

non-invasive sphygmomanometers). The device
complies with the ISO 81060-2 2013 (Non-Invasive
Sphygmomanometers - Part 2: Clinical Validation Of
Automated Measurement Type).
• The accuracy of this blood pressure monitor
has been carefully checked and developed with
regard to a long useful life. If the device is used
for commercial medical purposes, it must be
regularly tested for accuracy by appropriate means.
Precise instructions for checking accuracy may be
requested from the service address.

12. FCC Compliance Information

Wrist Blood Pressure Monitor BC 21
Responsible Party – U.S. Contact Information
Beurer North America LP
1 Oakwood Boulevard, Suite 255
Hollywood, FL 33020
United States
1-800-536-0366
info@beurer.com
FCC Compliance Statement
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
Changes or modifications not expressly approved by
the party responsible for compliance could void the
user's authority to operate the equipment.
NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
20