Beurer BC 21 Mode D'emploi page 10

or a decrease in the device's electromagnetic
immunity; this can result in faulty operation.
• Failure to comply with the above can impair the
performance of the device.
• The monitor requires 6 hours to warm from the
minimum/maximum storage temperature between
uses until the monitor is ready for its INTENDED
USE when the ambient temperature is 20 C°
NOTICE – To reduce the risk of product/property
damage:
• The blood pressure monitor is made up of precision
electronic components. Accuracy of readings and
the instrument's service life depend on careful
handling. Protect the unit against hard knocks
(e.g. dropping the unit), moisture, water, dirt, dust,
chemicals, extreme hot or cold temperatures, major
temperature fluctuations, direct exposure to sunlight
and heat sources which are too close (e.g. stoves,
heating radiators). This may damage the unit.
• The device must be stored in the specified ambient
conditions. Please see section 'Care, Maintenance
and Disposal' and section 'Technical Specification'
for details.
• Do not wash the unit in a washing machine, dish
washer or tumble dryer.
• Observe the local
disposal. Dispose of the device, components
and optional accessories according to applicable
local regulations. Unlawful disposal may cause
environmental pollution.
• Never attempt to repair, open and/or disassemble
the unit (including wrist cuff and optional accessory)
or adjust it yourself. This may damage the unit and
impair the functions. If you need to have the unit
repaired, please contact our customer service.
Please see warranty for service contact. Before
submitting any complaint, first check the batteries
and replace them if necessary.
• Changes or modifications to the device will nullify
the user warranty.
• Do not drop or insert any object into any opening.
This may damage the unit.
• Do not press the buttons with excessive force or
with pointed objects.
• To conserve the batteries, the monitor switches
off automatically if no buttons are pressed for 3
minutes.
• The device is only intended for the purpose
described in these instructions for use. The
manufacturer is not liable for damage resulting from
improper or careless use.
10
regulations for material