Storage Recommendations; Important Safety Instructions For Battery Chargers - DeWalt DC413 Guide D'utilisation

Outil de tronçonnage sans fil robuste de 28/36 v
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

The RBRC™ Seal
The RBRC™ (Rechargeable Battery Recycling
Corporation) Seal on the lithium ion battery (or
battery pack) indicates that the costs to recycle the
battery (or battery pack) at the end of its useful life
have already been paid by D
WALT.
E
RBRC™ in cooperation with D
E
established programs in the United States to facilitate the collection
of spent lithium ion batteries. Help protect our environment and
conserve natural resources by returning the spent lithium ion
battery to an authorized D
WALT service center or to your local
E
retailer for recycling. You may also contact your local recycling
center for information on where to drop off the spent battery.
RBRC™ is a registered trademark of the Rechargeable Battery Recycling
Corporation.

Storage Recommendations

1. The best storage place is one that is cool and dry away from
direct sunlight and excess heat or cold.
2. Long storage will not harm the battery pack or charger. Under
proper conditions, they can be stored for 5 years or more.
Important Safety Instructions for
Battery Chargers
SAVE THESE INSTRUCTIONS: This manual contains important
safety instructions for battery chargers.
• Before using charger, read all instructions and cautionary markings
on charger, battery pack, and product using battery pack.
WARNING: Shock hazard. Do not allow any liquid to get inside
charger.
CAUTION: Burn hazard. To reduce the risk of injury, charge only
D
WALT batteries. Other types of batteries may burst causing
E
personal injury and damage.
WALT and other battery users, has
CAUTION: Under certain conditions, with the charger plugged in to
the power supply, the charger can be shorted by foreign material.
Foreign materials of a conductive nature such as, but not limited to,
grinding dust, metal chips, steel wool, aluminum foil, or any buildup
of metallic particles should be kept away from charger cavities.
Always unplug the charger from the power supply when there is no
battery pack in the cavity. Unplug charger before attempting to
clean.
• DO NOT attempt to charge the battery pack with any chargers
other than the ones in this manual. The charger and battery
pack are specifically designed to work together.
• These chargers are not intended for any uses other than
charging D
WALT rechargeable batteries. Any other uses may
E
result in risk of fire, electric shock or electrocution.
• Do not expose charger to rain or snow.
• Pull by plug rather than cord when disconnecting charger.
This will reduce risk of damage to electric plug and cord.
• Make sure that cord is located so that it will not be stepped on,
tripped over, or otherwise subjected to damage or stress.
• Do not use an extension cord unless it is absolutely
necessary. Use of improper extension cord could result in risk
of fire, electric shock, or electrocution.
• An extension cord must have adequate wire size (AWG
or American Wire Gauge) for safety. The smaller the gauge
number of the wire, the greater the capacity of the cable, that is
16 gauge has more capacity than 18 gauge. When using more
than one extension to make up the total length, be sure each
individual extension contains at least the minimum wire size.
• Do not place any object on top of charger or place the
charger on a soft surface that might block the ventilation
slots and result in excessive internal heat. Place the charger
6

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Dc415

Table des Matières