Accessories - DeWalt DC413 Guide D'utilisation

NOTE: If the gear case and motor housing become separated
by more than 1/4" (6.35 mm), the tool must be serviced and re-
assembled by a D WALT service center. Failure to have the tool
E
serviced may cause brush, motor and bearing failure.
3. Re-install screws to attach the gear case to the motor housing.
Tighten screws to 18 in-lbs. (2.08 Nm) torque. Overtightening
could cause screws to strip.

Accessories

It is important to choose the correct guards, backing pads and
flanges to use with grinder accessories. See pages 11 and 12 for
information on choosing the correct accessories.
WARNING: Accessories must be rated for at least the speed
recom mended on the tool warning label. Wheels and other
accessories running over their rated accessory speed may fly apart
and cause injury. Threaded accessories must have a 5/8"-11 hub.
Every unthreaded accessory must have a 7/8" (22.2 mm) arbor hole.
If it does not, it may have been designed for a circular saw. Use only
the accessories shown on pages 11 and 12 of this manual.
Accessory ratings must always be above tool speed as shown on
tool nameplate.
Mounting Guard
MOUNTING AND REMOVING GUARD
WARNING: To reduce the risk of serious personal injury, turn
tool off and and remove battery pack before making any
adjustments or removing/installing attachments or accessories.
CAUTION: Guards must be used with all grinding wheels,
cutting wheels, sanding flap discs, wire brushes, and wire
wheels. The tool may be used without a guard only when sanding
with conventional sanding discs. D
are provided with guards intended for use with depressed center
wheels (Type 27) and hubbed grinding wheels (Type 27). The same
WALT models DC413 and DC415
E
guard is designed for use with sanding flap discs (Type 27 and 29)
and wire cup brushes. Grinding and cutting with wheels other than
Type 27 and 29 require different accessory guards included with tool.
A Type 1 guard is provided for use with a Type 1 wheel. Mounting
instructions for these accessory guards are included in the accessory
package.
1. Open the guard latch (L), and align the
lugs (M) on the guard with the slots (N)
on the gear case.
2. Push the guard down until the guard
lugs engage and rotate freely in the
groove on the gear case hub.
3. With the guard latch open, rotate the
guard (H) into the desired working
position. The guard body should be
positioned between the spindle and
the operator to provide maximum
operator protection.
4. Close the guard latch to secure the
guard on the gear case. You should
not be able to rotate the guard by
hand when the latch is closed. Do
not operate the grinder with a loose
guard or the clamp lever in open
position.
5. To remove the guard, open the guard
latch, rotate the guard so that the
lugs are aligned with the slots and
pull up on the guard.
NOTE: The guard is pre-adjusted to the
diameter of the gear case hub at the factory. If, after a period of time,
the guard becomes loose, tighten the adjusting screw (O) with clamp
lever in the closed position with guard installed on the tool.
10
M
N
L
H
O