DeWalt DC413 Guide D'utilisation page 21

5. To remove the wheel, grasp and turn while depressing the
spindle lock button.
USING CUTTING WHEELS
WARNING: Do not use edge grinding/cutting wheels for surface
grinding applications because these wheels are not designed for
side pressures encountered with surface grinding. Wheel breakage
and injury may result.
1. Allow tool to reach full speed before touching tool to work
surface.
2. Apply minimum pressure to work surface, allowing tool to
operate at high speed. Cutting rate is greatest when the tool
operates at high speed.
3. Once a cut is begun and a notch is established in the workpiece,
do not change the angle of the cut. Changing the angle will
cause the wheel to bend and may cause wheel breakage.
4. Remove the tool from work surface before turning tool off. Allow
the tool to stop rotating before setting it down.
MAINTENANCE
WARNING: To reduce the risk of serious personal injury,
turn tool off and and remove battery pack before making any
adjustments or removing/installing attachments or accessories.
Cleaning
WARNING: Blow dirt and dust out of all air vents with clean,
dry air at least once a week. To minimize the risk of eye
injury, always wear ANSI Z87.1 approved eye protection when
performing this. Exterior plastic parts may be cleaned with a damp
cloth and mild detergent. Although these parts are highly solvent
resistant, NEVER use solvents.
CHARGER CLEANING INSTRUCTIONS
WARNING: Shock hazard. Disconnect the charger from the AC
outlet before cleaning. Dirt and grease may be removed from the
exterior of the charger using a cloth or soft non-metallic brush. Do
not use water or any cleaning solutions.
Lubrication
D WALT tools are properly lubricated at the factory and are ready
E
for use.
Repairs
The charger is not user serviceable. There are no user serviceable
parts inside the charger. Servicing at an authorized service center is
required to avoid damage to static sensitive internal components.
To assure product SAFETY and RELIABILITY, repairs,
maintenance and adjustments (including brush inspection and
replacement) should be performed by a D
center, a D WALT authorized service center or other qualified
E
service personnel. Always use identical replacement parts.
Purchasing Accessories
WARNING: Since accessories, other than those offered by
D WALT, have not been tested with this product, use of such
E
accessories with this tool could be hazardous. To reduce the risk of
injury, only D WALT, recommended accessories should be used
E
with this product.
Recommended accessories for use with your tool are available at
extra cost from your local dealer or authorized service center. If you
need assistance in locating any accessory, please contact D
Industrial Tool Co., 701 East Joppa Road, Baltimore, MD 21286,
call 1-800-4-D WALT (1-800-433-9258) or visit our website www.
E
dewalt.com.
19
WALT factory service
E
WALT
E