Environmental Safety - DeWalt DC413 Guide D'utilisation

5. To remove the wheel, grasp and turn the backing pad and
sanding pad while depressing the spindle lock button.
USING SANDING BACKING PADS
Choose the proper grit sanding discs for your application. Sanding
discs are available in various grits. Coarse grits yield faster material
removal rates and a rougher finish. Finer grits yield slower material
removal and a smoother finish.
Begin with coarse grit discs for fast, rough material removal. Move
to a medium grit paper and finish with a fine grit disc for optimal
finish.
Coarse
Medium
Fine Finishing
Very Fine Finishing
1. Allow the tool to reach full speed before touching tool to the work
surface.
2. Apply minimum pressure to work surface, allowing the tool to
operate at high speed. Sanding rate is greatest when the tool
operates at high speed.
3. Maintain a 5˚ to 15˚ angle between the
tool and work surface. The san ding disc
should contact approximately
(25.4 mm) of work surface.
4. Move the tool constantly in a straight line to prevent burning and
swirling of work surface. Allowing the tool to rest on the work
surface without moving, or moving the tool in a circular motion
causes burning and swirling marks on the work surface.
5. Remove the tool from work surface before turning tool off. Allow
the tool to stop rotating before laying it down.
Precautions To Take When Sanding Paint
PERSONAL SAFETY
16 - 30 grit
36 - 80 grit
100 - 120 grit
150 - 180 grit
5˚-15˚
1"

ENVIRONMENTAL SAFETY

16
1. Sanding of lead based paint is NOT RECOMMENDED due to
the difficulty of controlling the contaminated dust. The greatest
danger of lead poisoning is to children and pregnant women.
2. Since it is difficult to identify whether or not a paint contains
lead without a chemical analysis, we recommend the following
precautions when sanding any paint:
1. No children or pregnant women should enter the work area
where the paint sanding is being done until all clean up is
completed.
2. A dust mask or respirator should be worn by all persons entering
the work area. The filter should be replaced daily or whenever
the wearer has difficulty breathing.
NOTE: Only those dust masks suitable for working with lead
paint dust and fumes should be used. Ordinary painting masks
do not offer this protection. See your local hardware dealer for
the proper N.I.O.S.H. approved mask.
3. NO EATING, DRINKING or SMOKING should be done in the
work area to prevent ingesting contaminated paint particles.
Workers should wash and clean up BEFORE eating, drinking or
smoking. Articles of food, drink, or smoking should not be left in
the work area where dust would settle on them.
1. Paint should be removed in such a manner as to minimize the
amount of dust generated.
2. Areas where paint removal is occurring should be sealed with
plastic sheeting of 4 mils thickness.
3. Sanding should be done in a manner to reduce tracking of paint
dust outside the work area.