Accessories - DeWalt DWE46044 Guide D'utilisation

3. Maintain a 5˚ to 10˚ angle between the tool and work surface for
wire cup brushes.
4. Maintain contact between the edge of the wheel and the work
surface with wire wheels.
5. Continuously move the tool in a forward and
backward motion to avoid creating gouges in
the work surface. Allowing the tool to rest on
the work surface without moving, or moving the
tool in a circular motion causes burning and
swirling marks on the work surface.
6. Remove the tool from the work surface before turning the tool off.
Allow the tool to stop rotating before setting it down.
CAUTION: Use extra care when working over an edge, as a
sudden sharp movement of grinder may be experienced.
MAINTENANCE
WARNING: To reduce the risk of injury, turn unit off and
disconnect it from power source before installing and removing
accessories, before adjusting or when making repairs. Before
reconnecting the tool, depress and release the trigger switch
to ensure that the tool is off. An accidental start-up can cause
injury.
Cleaning
WARNING: Blow dirt and dust out of all air vents with clean, dry
air at least once a week. To minimize the risk of eye injury, always wear
ANSI Z87.1 approved eye protection when performing this.
WARNING: Never use solvents or other harsh chemicals for
cleaning the non-metallic parts of the tool. These chemicals may
weaken the plastic materials used in these parts. Use a cloth
dampened only with water and mild soap. Never let any liquid get
inside the tool; never immerse any part of the tool into a liquid.

Accessories

WARNING: Since accessories, other than those offered by
D WALT, have not been tested with this product, use of such
e
accessories with this tool could be hazardous. To reduce the risk of
FIG. 22
injury, only D
e
this product.
WARNING: Handle and store all abrasive wheels carefully to
prevent damage from thermal shock, heat, mechanical damage, etc.
Store in a dry protected area free from high humidity, freezing
temperatures or extreme temperature changes.
The capacities of these grinders are as follows:
– DWE46044, DWE46066 - 5"/6" (127 mm/152 mm)
diameter x 3/32" (2.38 mm) thick cutting wheels. These units
can utilize up to 1/4" (6.35 mm) thick grinding wheels if a Type
27 guard (optional) is installed.
It is important to choose the correct guards, backing pads and
flanges to use with grinder accessories. See the Accessory Chart
for information on choosing the correct accessories.
WARNING: Accessories must be rated for at least the speed
recom mended on the tool warning label. Wheels and other accessories
running over rated accessory speed may burst and cause injury.
Threaded accessories must have a 5/8"-11 hub. Every unthreaded
accessory must have a 7/8" (22.2 mm) arbor hole. If it does not, it
may have been designed for a circular saw and should not be used.
Use only the accessories shown in the Accessory Chart of this
manual. Accessory ratings must be above listed minimum wheel
speed as shown on tool nameplate.
Recommended accessories for use with your tool are available at
extra cost from your local dealer or authorized service center. If you
need assistance in locating any accessory, please contact D
18
WALT recommended accessories should be used with
WALT
e