Intended Use - DeWalt DWE46044 Guide D'utilisation

FIG. 2
Q
M
N
DWE4606
M. Guard opening adjustment
lever
N. Wheel change release
button
O. Guard stop screw

INTENDED USE

The DWE46044 and DWE46066 heavy-duty angle grinders
have been designed for professional grinding at various
work sites (i.e., construction sites). DO NOT use under wet
conditions or in presence of flammable liquids or gases.
These heavy-duty angle grinders are professional power tools. DO
NOT let children come into contact with the tool. Supervision is
required when inexperienced operators use this tool.
R
P
O
P. Guard latch
Q. Guard latch adjustment
screw
R. Outer guard
SPINDLE LOCK (FIG. 3)
The spindle lock (E) is provided to prevent the spindle from rotating
when installing or removing wheels. Operate the spindle lock only
when the tool is turned off, unplugged
from the power supply, and has come to a
complete stop. Do not engage the spindle
lock while the tool is operating because
damage to the tool will result. To engage
the lock, depress the spindle lock button
and rotate the spindle until you are unable
to rotate the spindle further.
Guards and Flanges
It is important to choose the correct guards and flanges to use
with the grinder accessories. See Accessory Chart for the correct
accessories.
NOTE: Edge grinding and cutting can be performed with Type 27
wheels designed and specified for this purpose.
CAUTION: Purchase and install the proper Type 27 guard to use
Type 27 wheels.
WARNING: Accessories must be rated for at least the speed
recom mended on the tool warning label. Wheels and other accessories
running over rated accessory speed may burst and cause injury.
Every unthreaded accessory must have a 7/8" (22.2 mm) arbor hole.
If it does not, it may have been designed for a circular saw and should
not be used. Use only the accessories shown in the Accessory
Chart. Accessory ratings must be above listed minimum wheel
speed as shown on tool nameplate.
9
FIG. 3
E