ESGE-Zauberstab GASTRO 200 Notice D'utilisation page 27

whaT can be Done ...
if The Drive shafT of your aPPLiance no Longer roTaTes?
if aTTachmenTs Do noT hoLD TighT on The shafT?
if aTTachmenTs cannoT be removeD from The shafT?
WaRnInG:
Replace damaged attachments immediately. No liability in case of damaged attachments!
When you have not used your appliance for a fairly long time
the drive shaft may get stuck due to small foodstuff residues
which have hardened and are now gumming up the lower
shaft bearing.
Place your ESGE-Zauberstab
with hot water and a mild detergent, then switch it on. In
general your ESGE-Zauberstab
just try to free the shaft carefully with pliers.
Should the shaft still not rotate, the fault probably lies else-
where, and the appliance should be sent to our repair service.
If an attachment no longer fits tightly on the stub, simply
pinch the spring blades of the attachment together with a pair
of pliers. Remove the accessories from time to time from the
shaft and clean the shaft. Otherwise the lower socket may be
blocked because of insufficient cleaning.
If sticky ingredients such as egg, sugar, honey are processed,
it is best to hold the appliance together with the attachment
for a minute or two in the washing-up water. Water will not
harm the housing, but the cable outlet must not get wet.
for about 5 minutes in a jug
®
will then work again; if not,
®
27